Primetherm-Fix

Properties

Simple and quick application, low cost, high durability, controlled shrinkage and excellent adhesion properties.

Composition

Composed of cement, mineral fillers, resins and specific additives.

Support

Ceramic brick masonry, Cement/Thermal Block and Cementitious plaster.

IApplication instructions

• Knead Primetherm-Fix with 6L of clean water per 25kg bag of powder, manually or with a slow electric mixer until you obtain a consistent, homogeneous dough without lumps. Leave the dough to rest for 5 minutes, give it a little stir and it will be ready to use;
• The addition of other products may compromise the characteristics of the mortar;
• Insulation panels can be glued in two ways: by total gluing with the support bar and the face of the panel to be glued, using a notched trowel with the appropriate tooth size to ensure uniform adhesion across the entire piece, or by applying a perimeter bead of mortar all around the panel plus an X-shaped bead in the center of the panel;
• The plates must be placed in a staggered manner, that is, in an inverted position;
• Carry out a preliminary study of the positioning of the panels, taking into account the existence of windows, doors, window sills, projections, corners and balconies. The panels are glued from the bottom up, placing the starting profile and respective frame;
• When gluing the panels, avoid the presence of adhesive mortar in the joints between panels, in order to avoid thermal bridges. Fill the gaps in the joints between panels with the same insulating material;
• After the bonding product has dried, apply dowels suitable for the type of substrate and the type of insulation, applying at least 6 to 8 dowels/m2 ^. This mechanical fixing is a supplementary complement and does not replace gluing. The fixing point of the dowels must coincide with the gluing points;
• Consult the ETIC Application Manual – Primefix.